Mid-Row Cable Retractor Adapter Bracket for FT2-202 Series
Allows a single cable retractor to be installed in the middle position within a Crestron® FT2-202 Series FlipTop™.
Configure your FlipTop now!
Launch Configurator
The FT2A-CBLR-BRKT-202 is an adapter bracket for a Crestron® FT2‑202 Series FlipTop™ that enables the installation of a single cable retractor in the middle position within the FlipTop. It attaches to the front or rear of the FlipTop chassis, and provides mounting slots for one retractor and one power supply.
FT2‑202 Series FlipTops normally support the installation of cable retractors at the left and right ends of the module row. Adding the FT2A-CBLR-BRKT-202 bracket allows a retractor to be installed in the middle of the row, allowing for a total of up to three retractors across the entire row. The mid‑row retractor occupies the third and fourth module slots of the row.
When installing a mid‑row retractor, the bracket and retractor can attach to either the front or rear of the FlipTop chassis below the table. When installed, the mid‑row retractor enclosure projects from the front or rear of the chassis perpendicular to the end‑mounted retractors. The cable connector nests within the retractor module above the table at a 90° rotation relative to other connectors within the FlipTop.
Note: Using the bracket, an FT2A‑CBLR‑GR Series Gravity Retractor requires 2‑3/4 inches (70 mm) horizontal clearance, and an FT2A‑CBLR‑1T Series One‑Touch Retractor requires 9 inches (228 mm) horizontal clearance, measured from the front or rear of the FlipTop chassis beneath the table. Refer to each product's spec sheet for additional dimensions and clearances.
When used with an FT2‑202‑ELEC Series "Electrical" FlipTop, the FT2A-CBLR-BRKT-202 bracket retains the ability to mount a single FT2A‑UTK‑PWS power supply on the same side as the cable retractor.
Key Features
- Enables installastion of one cable retractor in the middle module position within an FT2‑202 Series FlipTop™
- Attaches below the table to the front or rear of the FlipTop chassis
- Provides mounting slots for one retractor and one power supply
- Compatible with FT2‑202‑MECH and FT2‑202‑ELEC Series FlipTops™
- Compatible with Gravity Retractors and One‑Touch Retractors (FT2A‑CBLR‑GR and FT2A‑CBLR‑1T Series respectively)
There are no additional specifications available for this product.
Click
here to search product certificates.
Please select your region below to see the appropriate Advertised Pricing.