Products

    Pages

        CN-TVAV

        TV/AV Controller Module

        Provides a complete control interface for a television or other AV device.

        The CN-TVAV is a control module designed for use as part of a Crestron® control system to provide control of a television, video monitor, or other AV device. IR and RS-232 control ports are included for controlling the device, and built-in current sensing provides for detection of the device’s on and off power states. Four Versiport I/O ports enable the integration of external power sensors, motion detectors, door switches, alarms, or anything else that provides a dry contact closure, low-voltage logic, or 0-10 Volt DC signal. The CN-TVAV communicates with the control system via Cresnet®.

        Its built-in IR receiver provides compatibility with the WPR-48 handheld remote (sold separately), allowing for a complete, fully-customizable TV control solution.

        The CN-TVAV is housed in a compact metal enclosure that can be placed on a shelf, attached under a table, or mounted in a 19” equipment rack.[1] Its 1RU half-width form factor allows it to fit in a single rack-space alongside a second CN-TVAV or other 1RU half-width Crestron device. An array of indicators is provided on the front panel for easy setup and troubleshooting.

         
        Key Features
        • Provides a control interface for a single television or video monitor
        • Includes programmable IR and bidirectional RS-232 control ports
        • Ships with one IR emitter included
        • Built-in current sensor detects the on/off power state of the connected 120V AC powered device
        • Includes four Versiports for integration of contact-closure, low-voltage logic, and 0-10V devices
        • Compatible with the WPR-48 handheld IR remote
        • Integrates with a Crestron® control system via Cresnet®
        • Single-space, half-width 19-inch rack-mountable [1]
        • Under-table mountable [1]
        • 120 Volts AC powered
        1. ST-RMK Rack Mount Kit and UTK-1U-HALF Under-Table Mounting Kit sold separately.

        This product may be purchased from an authorized Crestron dealer. To find a dealer, please contact the Crestron sales representative for your area. A list of sales representatives is available online at www.crestron.com/salesreps or by calling 800-237-2041.

        The specific patents that cover Crestron products are listed online at: patents.crestron.com.

        Certain Crestron products contain open source software. For specific information, please visit www.crestron.com/opensource.

        Crestron, the Crestron logo, Cresnet, and Master Blaster are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or other countries. Other trademarks, registered trademarks, and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any proprietary interest in the marks and names of others. Crestron is not responsible for errors in typography or photography. Specifications are subject to change without notice. ©2015 Crestron Electronics, Inc.

         
        Connectors
          CRESNET (1) 6-pin RJ11 female, Cresnet® slave port
          RS-232 (1) 6-pin RJ11 female, bidirectional RS-232 COM port;
        Up to 115.2K baud; hardware and software handshaking support
          I/O 1 – 4 (1) 5-pin 3.5 mm detachable terminal block comprising (4) "Versiport" digital input/output or analog input ports (referenced to GND);
        Digital Input: Rated for 0-24 Volts DC, input impedance 20k ohms, logic threshold 1.24 Volts DC;
        Digital Output: 250 mA sink from maximum 24 Volts DC, catch diodes for use with “real world” loads;
        Analog Input: Rated for 0-10 Volts DC, protected to 24 Volts DC maximum, input impedance 20k Ohms;
        Programmable 5 Volts, 2k Ohms pull-up resistor per pin
          IR (1) 3.5 mm mini phone jack, IR/Serial output port;
        IR output up to 1.2 MHz;
        1-way serial TTL/RS-232 (0-5 Volts) up to 115.2k baud;
        One (1) STIRP IR emitter included;
        Expandable via ST-SPL to control multiple disparate IR devices
          POWER OUT (1) NEMA 5 AC power outlet;
        Current-sensing AC power outlet for television or display device;
        Maximum Load: 6 Amps (700 Watts) at 120 Volts AC
          POWER IN (1) Attached 6 ft (1.83 m) grounded AC power cord
        IR Receiver
          IR Reception Frequency 455 kHz
          IR Reception Angle ~30° from center
        Indicators
          PWR (1) green LED, indicates operating power supplied from a 120V AC power source
          NET (1) amber LED, indicates communication with the Cresnet system
          INPUT-OUTPUT (1 – 4) (4) red LEDs, each indicates an input or output signal at the corresponding I/O port
          TV/AV PWR (1) green LED, indicates the device connected to the POWER OUT outlet is "on"
          TV/AV IR (1) red LED, indicates transmission of a control signal via the IR port
          RS-232 RXD (1) red LED, indicates reception of a control signal at the RS-232 port
          RS-232 TXD (1) red LED, indicates transmission of a control signal at the RS-232 port
          IR IN (1) red LED, indicates reception of a valid IR control signal
        Power Requirements
          Module Power 0.6 Amps @ 120 Volts AC, 60 Hz
          Device Power Up to 6 Amps @ 120 Volts AC, 60 Hz (in addition to Module Power)
          Cresnet Power Usage 0 Watts
        Environmental
          Temperature 41° to 113° F (5° to 45° C)
          Humidity 10% to 90% RH (non-condensing)
        Enclosure
          Chassis Metal, black finish
          Front Panel Metal, black finish with polycarbonate label overlay
          Mounting Freestanding, under-table mountable, or 1RU half-width 19-inch rack-mountable (adhesive feet included, under-table and rack mounting kits sold separately)
        Dimensions
          Height 1.70 in (44 mm);
        1.80 in (46 mm) with feet
          Width 7.07 in (180 mm)
          Depth 6.32 in (161 mm)
        Weight
          3.63 lb (1.65 kg)
        1. ST-RMK Rack Mount Kit and UTK-1U-HALF Under-Table Mounting Kit sold separately.

        This product may be purchased from an authorized Crestron dealer. To find a dealer, please contact the Crestron sales representative for your area. A list of sales representatives is available online at www.crestron.com/salesreps or by calling 800-237-2041.

        The specific patents that cover Crestron products are listed online at: patents.crestron.com.

        Certain Crestron products contain open source software. For specific information, please visit www.crestron.com/opensource.

        Crestron, the Crestron logo, Cresnet, and Master Blaster are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or other countries. Other trademarks, registered trademarks, and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any proprietary interest in the marks and names of others. Crestron is not responsible for errors in typography or photography. Specifications are subject to change without notice. ©2015 Crestron Electronics, Inc.