DigitalMedia™ CAT Repeater
This product has been discontinued. Please contact Crestron True Blue Support at 1-888-CRESTRON for a replacement solution or more information.
Enables DM® CAT wire runs up to 450 feet using DigitalMedia™ Cable.
The DM-DR is designed for use with DM® CAT transmitters and receivers to enable extended cable lengths up to 450 ft (137 m). Up to 2 repeaters per DM device may be required. Please consult the spec sheet for each DM CAT device to confirm actual capabilities.
Its low-profile design allows the DM-DR to be installed discreetly in an equipment closet or similar space. It mounts to a standard 2-gang, 4" square, or UK electrical box using the mounting bracket provided, affording a clean installation that protrudes a mere 1-1/8" inches from the mounting surface. All connections are made on the rear panel within the electrical box. An array of indicators is provided on the front panel for easy setup and troubleshooting.
Please refer to the DigitalMedia Resources Webpage at http://www.crestron.com/dmresources/ for additional design tools and reference documents.
- DigitalMedia™ CAT repeater
- Enables up to 450 ft (137 m) DM® cable length
- Regenerates the digital signal for error-free delivery
- Passes all AV, control, networking, and power signals supported by DigitalMedia
- Allows quick, easy setup and diagnostics
- Low-profile design mounts to a 2-gang, 4" square, or UK wall box
- Powered over the DMNet® connection
| ||DISPLAY D & M ||(1) DM CAT output composed of (2) 8-pin RJ45 female, shielded; |
Connects to DM CAT input of a DM receiver/room controller, switcher, or other DM device via DM-CBL cable
| ||DISPLAY 24 A B G ||(1) 4-pin 3.5mm detachable terminal block, DMNet port; |
Connects to DMNet port of a DM receiver/room controller, switcher, or other DM device via DM-CBL cable
| ||SOURCE D & M ||(1) DM CAT input composed of (2) 8-pin RJ45 female, shielded; |
Connects to DM CAT output of a DM switcher, transmitter, or other DM device via DM-CBL cable
| ||SOURCE 24 A B G ||(1) 4-pin 3.5mm detachable terminal block, DMNet port; |
Connects to DMNet port of a DM switcher, transmitter, or other DM device via DM-CBL cable
|Controls & Indicators |
| ||PWR ||(1) green LED, indicates operating power supplied via DMNet |
| ||DM LINK ||(1) green LED, indicates DM link status |
| ||VIDEO ||(1) red/green dual-color LED, indicates video signal presence and lock status |
|Power Requirements |
| ||DMNet Power Usage ||3 Watts (0.125 Amps @ 24 Volts DC) |
| ||Temperature ||41° to 104°F (5° to 40°C) |
| ||Humidity ||10% to 90% RH (non-condensing) |
| ||Heat Dissipation ||10 BTU/hr |
| ||Chassis ||Metal with black finish |
| ||Mounting ||Mounts to a 2-gang electrical box, 4” square box, or 1-gang UK (BS 4662) electrical box |
| ||Height ||4.92 in (125 mm) |
| ||Width ||5.25 in (134 mm) |
| ||Depth ||1.40 in (36 mm) |
| || |
16.0 oz (454 g)
to search product certificates.