Zum™ Wireless Wall-Box Switch, 5A, 100-277V, White Smooth
A wireless wall-box switch for 100-277 Volt lighting control in a Zūm™ commercial room lighting system.
Faceplate sold separately.
The Zūm™ wireless wall-box switch (ZUMMESH-5A-SW) provides control of a single switched 5 Amp, 100-277 Volt lighting load. It features a single rocker switch to enable simple on/off switching. Standard gang-box installation allows one or more units to be installed in a 3-1/2 inch (89 mm) deep electrical box (decorator-style faceplate sold separately).
Zūm Mesh wireless technology affords easy “pair and play” integration as part of a complete Zūm commercial room lighting system. Energy-saving options are available to enable occupancy or vacancy sensing, and centralized monitoring and management.[1]
Energy Efficiency
Occupancy or vacancy sensor connectivity drive the potential for significant energy savings by turning lights off automatically when the room is vacant to reduce energy usage.
Pair and Play
Designed with flexibility and ease-of-use in mind, Zūm switches are pre-programmed with “pair and play” functionality. An installer can simply install the switch in a room along with Zūm occupancy sensors or vacancy sensors, set up the room with a few quick button taps, and then use the switch to control the lights in the room – no programming required! Room setup can also be accomplished using the Zūm app if the room is equipped with a Zūm Network Bridge. The Zūm Network Bridge also enables centralize monitoring and management via a Zūm Floor Hub and Zūm Net Wireless Gateway.[1]
Zūm Mesh Wireless Technology
Ultra-reliable Zūm Mesh wireless technology provides steadfast peer-to-peer RF communications within a commercial space without the need for physical control wiring, hubs, or gateways. Employing a Wi-Fi® friendly 2.4 GHz peer-to-peer mesh network topology, nearly every Zūm Mesh device acts as a “routing node,” relaying wireless commands directly between Zūm Mesh devices to ensure that every command reaches its intended destination without disruption.
Zūm Mesh is smart! Every Zūm Mesh device knows its purpose and just the right messages to communicate to other Zūm Mesh devices within the space. Each Zūm Mesh device that is added to the space effectively increases the range and stability of the peer-to-peer mesh network by providing multiple redundant signal paths. Each Zūm Mesh device auto-negotiates its RF channel to provide robust communication and is protected through AES 128-bit encryption. The wireless range between any two Zūm Mesh devices is typically 50 feet (15 meters).[2]
Please refer to the Zūm Lighting Control System Setup Guide (Doc # 7957A) for additional information.
Key Features
- Zūm™ wireless wall-box switch
- Pair and play with Zūm occupancy sensors or vacancy sensors [1]
- Zūm Mesh peer-to-peer RF communications for easy integration into a complete standalone or networked Zūm wireless lighting control solution [2]
- Single rocker switch and status LED
- Controls switched lighting loads
- Rated 5 Amps at 100-277 Volts AC
- Flying lead wiring connections
- Standard 3-1/2 inch (89 mm) deep electrical box installation
- Available in smooth black, white, almond, gray, or red finish
- Matching decorator-style faceplate available separately
- Meets UL® 916 standard for energy management equipment
- Meets CEC Title 24 energy efficiency standards [3]
- Meets ASHRAE® 90.1 energy efficiency standards [4]
- ICC® International Energy Conservation Code® compliant [5]
Load Control |
|
Switched Load Types |
LED, fluorescent ballast, incandescent, magnetic low-voltage, electronic low-voltage, neon/cold cathode, high-intensity discharge |
|
Load Rating |
5 Amps, latching on/off relay |
|
Line/Load Voltage |
100-277 Volts AC, 50/60 Hz |
|
Idle Power Consumption |
<1 Watt |
Wireless Communications |
|
RF Transceiver |
Zūm Mesh 2-way RF, 2.4 GHz ISM Channels 15, 20, 25, or 26 (channel auto-selected), IEEE 802.15.4 compliant |
|
Range |
50 ft (15 m) to nearest peer-to-peer mesh network device(s), subject to site-specific conditions and individual device capabilities [2] |
|
Note: A maximum of 32 Zūm Mesh wireless devices is permitted per room. |
Controls & Indicators |
|
Switch |
(1) 3-Position rocker switch (spring return to center); press up to turn the lighting load on, press down to turn the lighting load off; also used for room setup and factory reset |
|
Status |
(1) Green LED, indicates the lighting load is turned on; also used for room setup and factory reset |
Connections |
|
Hot |
(1) 16 AWG Class 1 flying lead, black, line power input |
|
Neutral |
(1) 16 AWG Class 1 flying leads, white, neutral |
|
Ground |
(1) 16 AWG Class 1 flying lead, green, ground |
|
Switched Load |
(1) 16 AWG Class 1 flying lead, red, switched load output |
Environmental |
|
Temperature |
32° to 104° F (0° to 40° C) |
|
Humidity |
10% to 90% RH (non-condensing) |
Construction |
|
Composition |
Plastic housing and front face with metal bracket |
|
Mounting |
Mounts in a 1-gang (or larger) 3-1/2 inch (89 mm) deep electrical box (not included) |
|
Faceplate |
Requires a decorator-style faceplate (sold separately) |
Dimensions |
|
Height |
4.13 in (105 mm) |
|
Width |
1.75 in (45 mm) |
|
Depth |
1.80 in (46 mm) |
Weight |
|
5 oz (142 g) |
Compliance |
|
UL Listed for US & Canada, IC, FCC Part 15 Class A digital device, UL 916, CEC Title 24 [3], ASHRAE 90.1 [4], IECC [5] |
Click
here to search product certificates.
Please select your region below to see the appropriate Advertised Pricing.