This product has been discontinued. Please contact Crestron True Blue Support at 1-888-CRESTRON for a replacement solution or more information.
Provides a complete control interface for a television or other AV device.
The CN-TVAV is a control module designed for use as part of a Crestron® control system to provide control of a television, video monitor, or other AV device. IR and RS-232 control ports are included for controlling the device, and built-in current sensing provides for detection of the device’s on and off power states. Four Versiport I/O ports enable the integration of external power sensors, motion detectors, door switches, alarms, or anything else that provides a dry contact closure, low-voltage logic, or 0-10 Volt DC signal. The CN-TVAV communicates with the control system via Cresnet®.
Its built-in IR receiver provides compatibility with the WPR-48 handheld remote (sold separately), allowing for a complete, fully-customizable TV control solution.
The CN-TVAV is housed in a compact metal enclosure that can be placed on a shelf, attached under a table, or mounted in a 19” equipment rack.[1] Its 1RU half-width form factor allows it to fit in a single rack-space alongside a second CN-TVAV or other 1RU half-width Crestron device. An array of indicators is provided on the front panel for easy setup and troubleshooting.
Key Features
- Provides a control interface for a single television or video monitor
- Includes programmable IR and bidirectional RS-232 control ports
- Ships with one IR emitter included
- Built-in current sensor detects the on/off power state of the connected 120V AC powered device
- Includes four Versiports for integration of contact-closure, low-voltage logic, and 0-10V devices
- Compatible with the WPR-48 handheld IR remote
- Integrates with a Crestron® control system via Cresnet®
- Single-space, half-width 19-inch rack-mountable [1]
- Under-table mountable [1]
- 120 Volts AC powered
| Connectors |
| |
CRESNET |
(1) 6-pin RJ11 female, Cresnet® slave port |
| |
RS-232 |
(1) 6-pin RJ11 female, bidirectional RS-232 COM port;
Up to 115.2K baud; hardware and software handshaking support |
| |
I/O 1 – 4 |
(1) 5-pin 3.5 mm detachable terminal block comprising (4) "Versiport" digital input/output or analog input ports (referenced to GND);
Digital Input: Rated for 0-24 Volts DC, input impedance 20k ohms, logic threshold 1.24 Volts DC;
Digital Output: 250 mA sink from maximum 24 Volts DC, catch diodes for use with “real world” loads;
Analog Input: Rated for 0-10 Volts DC, protected to 24 Volts DC maximum, input impedance 20k Ohms;
Programmable 5 Volts, 2k Ohms pull-up resistor per pin |
| |
IR |
(1) 3.5 mm mini phone jack, IR/Serial output port;
IR output up to 1.2 MHz;
1-way serial TTL/RS-232 (0-5 Volts) up to 115.2k baud;
One (1) STIRP IR emitter included;
Expandable via ST-SPL to control multiple disparate IR devices |
| |
POWER OUT |
(1) NEMA 5 AC power outlet;
Current-sensing AC power outlet for television or display device;
Maximum Load: 6 Amps (700 Watts) at 120 Volts AC |
| |
POWER IN |
(1) Attached 6 ft (1.83 m) grounded AC power cord |
| IR Receiver |
| |
IR Reception Frequency |
455 kHz |
| |
IR Reception Angle |
~30° from center |
| Indicators |
| |
PWR |
(1) green LED, indicates operating power supplied from a 120V AC power source |
| |
NET |
(1) amber LED, indicates communication with the Cresnet system |
| |
INPUT-OUTPUT (1 – 4) |
(4) red LEDs, each indicates an input or output signal at the corresponding I/O port |
| |
TV/AV PWR |
(1) green LED, indicates the device connected to the POWER OUT outlet is "on" |
| |
TV/AV IR |
(1) red LED, indicates transmission of a control signal via the IR port |
| |
RS-232 RXD |
(1) red LED, indicates reception of a control signal at the RS-232 port |
| |
RS-232 TXD |
(1) red LED, indicates transmission of a control signal at the RS-232 port |
| |
IR IN |
(1) red LED, indicates reception of a valid IR control signal |
| Power Requirements |
| |
Module Power |
0.6 Amps @ 120 Volts AC, 60 Hz |
| |
Device Power |
Up to 6 Amps @ 120 Volts AC, 60 Hz (in addition to Module Power) |
| |
Cresnet Power Usage |
0 Watts |
| Environmental |
| |
Temperature |
41° to 113° F (5° to 45° C) |
| |
Humidity |
10% to 90% RH (non-condensing) |
| Enclosure |
| |
Chassis |
Metal, black finish |
| |
Front Panel |
Metal, black finish with polycarbonate label overlay |
| |
Mounting |
Freestanding, under-table mountable, or 1RU half-width 19-inch rack-mountable (adhesive feet included, under-table and rack mounting kits sold separately) |
| Dimensions |
| |
Height |
1.70 in (44 mm);
1.80 in (46 mm) with feet |
| |
Width |
7.07 in (180 mm) |
| |
Depth |
6.32 in (161 mm) |
| Weight |
| |
3.63 lb (1.65 kg) |
Click
here to search product certificates.
Please select your region below to see the appropriate Advertised Pricing.